Page tree
Skip to end of metadata
Go to start of metadata

Telnet Commands Related to Log Configuration

Applies to:
SAP NetWeaver 7.1 and higher

Using the LOG group of commands, you can configure the logging of your system.
Enable the group with ADD LOG

Reconfigures registered log controllers in the logging service.
-? | -H Displays the help message.
OID- ID of the object that is going to be edited.
The OID identifier must represent a valid name for the logging service.

Gives information about the existing log controllers.

Creates a new log controller.
Note: only "named" log controller can be edited (name is case sensitive) and this operation will affect all the users of this log controller.

log_list |grep <location>
Use the command to make sure that the location is successfully enabled

If the needed location does not exist, you have to create it before you enable traces.