Skip to end of metadata
Go to start of metadata

Question:

How can I set up QM so that batch specifications are valuated.

Answer:

In oder to set up QM and enable batch valuation the following setting has to be checked:

Transaction: QCC0

Path: Quality Management - Basic Settings - Maintain Settings at Plant Level (Select a plant)

Tabstrip: Inspection lot completion
Check the flag Batch valuation without Material Spec. (TQSS1-VALNOSPEC)

Batch Valuation Possible Without Specification

Use

If you set this indicator, a link between the master inspection characteristics and the class characteristics for the batch class must exist when an inspection lot is created, for batch valuation to occur when the usage decision or inspection point valuation is made. A link within the material specification is not required.

If you do not set this indicator, batch valuation only occurs when the usage decision or inspection point valuation is made, if a link using the material specification exists between the master inspection characteristics and the class characteristics for the batch class. In this way, you can control on a material-dependent basis whether the batch characteristics are valuated based on the inspection results.