Page tree
Skip to end of metadata
Go to start of metadata

Check if the DPC Pull ST_PI Extractor is activated

The following steps are generally applicable to any extractor.


  1. Navigate to Solution Manager Administration Work ccenter
  2. Select the  Infrastructure panel.
  3. Select the Alert Framework in the Framework menu.
  4. In the filter select System ID and it is the extractor with the Extended Context "ST_PI"
  5. If the extractor does not exist then check the set up as shown in below in Link to Solution Manager Setup
  6. Check the Active Status column of the extractor and if it is showing a grey light bulb then it is not active as shown in the figure below:

How to reactivate

  1. Select the extractor
  2. Above the table of extractors select the pencil icon to go into mode edit
  3. Then select the "Activate" button to the right of the pencil as shown in the figure below:

Link in Solution Manager Setup

This extractor is created when doing the System Monitoring setup of the ABAP System:

Go to the Work Center: SAP Solution Manager: Configuration  -> Technical Monitoring -> System Monitoring Scenario -> Step 6 Setup Monitoring

  • No labels